![]() ![]() You only need a light coating so it doesn’t drip. Next, spray the inside of each piece of trim with the spray adhesive. Use a very sharp knife for cutting and where you have 90-degree angles, cut each strip to 45 degrees so they fit closely and cleanly against each other. If you’re not certain about your measurements, allow a little extra because you can trim it back later. Step 4 - Fit New Trimīefore you actually fit the new trim, you need to measure the sides of the window and cut the trim to size if it comes in large lengths. Gently brush a small amount of primer over any bare metal to prevent rusting at a later date. When you’ve finished, clean the surface with a damp rag and allow the metal to dry thoroughly. Use a coarse-textured sandpaper to go all the way to the metal. This is important because the sanded metal will give a better surface for the new adhesive. Use sandpaper to scour the area beneath the adhesive and trim, ensuring you get rid of any particles that remain. Using masking tape as a barrier can help prevent damage to paintwork. Go slowly and scrape as hard as you can, but make sure only to scrape the area where there was trim and adhesive, otherwise you’ll mark the paintwork. Using the small metal scraper, go all around the window to remove the rest of the adhesive and any of the rubber trim you couldn’t get off with the screwdriver. Make sure to get off as much of the adhesive holding on the trim as possible. You’ll usually need to work from a number of different angles. Work your way gradually around the window until you’ve removed as much of the trim as possible. Depending on how old the trim is, it should come off fairly easily in long strips. Next, begin prying off the old trim using a flat head screwdriver.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |